Display Warehouse

Focal Wall Instructions

Measure wall area and find the center of the wall.	Measure and cut out electrical outlets, if applicable.	Install main 12" on center slatwall panel, make sure panel is level..
Screw main panel to wall.	Install 2 foot slatwall sections left and right.	Line up vertical slots.
		Screw the three panels to wall.
Done.	Measure wall and cut slatwall if necessary.	Make sure you leave 3/4 inch for trim.
Cut out electrical outlets if necessary.	Measure, level and install 8 foot sections.
Install remaining slatwall panels.	Install furring above 4x8 slatwall panels (for the height of backing, JIG will be provided).	Install furring on both sides for facia above slatwall.
Install furring on slatwall for supports.	Install lower base.	Slide supports into furring and nail in.
Done
Screw canopy together, if applicable.	Place canopy on top of supports and screw into wall.	Done.
Level and screw in trusses.	Measure all the way to the edge of the wall, in case facia needs cutting.
	Staple facia to furring.
Done.	Put in canopy lights	Slide in left and right bases.
Shim if necessary.		Apply edge trim to slatwall
	This is what the unit should look like when completed.